Dynex DX-LCD37-09-2 User Manual download pdf (Page 6)

Features

Lightning

For added protection for your TV’s receiver during a lightning storm, or

when it is left unattended and unused for long periods of time, unplug

it from the power outlet and disconnect the antenna or cable system.

This helps prevent damage to your TV from lightning and power line

surges.

Screen protection

Your TV’s screen is made of glass. Do not drop your TV or hit the glass

screen. If the screen breaks, be careful of broken glass.

Pixel defect

Your TV’s screen is designed to display finely detailed pictures.

Occasionally, a few non-active pixels may appear on the screen as fixed

points of blue, green, or red. This is not a defect and does not affect your

TV’s performance.

Power lines

An outside antenna system should not be located in the vicinity of

overhead power lines or other electric light of power circuits, or where it

can fall into such power lines or circuits.

When installing an outside antenna system, extreme care should be

taken to keep from touching such power lines or circuits as contact with

them might be fatal.

Temperature

Do not use in hot or cold locations. If you use your TV in a cold location,

the picture may leave trails or appear slightly delayed. This is not a

malfunction. Your TV will return to normal operation when the

temperature returns to normal.

Do not leave your TV in a hot or cold location. Do not install your TV in a

location that is exposed to direct sunlight or near a heater. The cabinet

may warp and the screen may malfunction.

Storage temperature: 32°F to 122°F (0°C to 50°C)

Operating temperature: 41°F to 104°F (5°C to 40°C)

After Image

If you display a fixed image on the screen for an extended amount of

time, a permanent after image may be burned into the screen. To avoid

this type of damage:

• Reduce the brightness and contrast settings to a minimum

viewing level.

• Do not display a fixed image for an extended period of time.

Examples of fixed images include logos, video games, computer

images, teletext, and images displayed in 4:3 mode. This type of

damage is not covered by your warranty.

• Turn off your TV when it is not in use

Outdoor antenna grounding

If an outside antenna or cable system is connected to your TV, make sure

that the antenna or cable system is grounded to provide some

protection against voltage surges and built-up static charges. Article

810 of the National Electrical Code, ANSI/NFPA No. 70, provides

information with respect to correct grounding of the mast and

supporting structure, grounding of the lead-in wire to an antenna

discharge unit, size of grounding conductors, location of the

antenna-discharge unit, connection to grounding electrodes, and

requirements for the grounding electrode.

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to

Article 820-40 of the NEC that provides guidelines for correct grounding

and in particular, specifies that the cable ground must be connected to

the grounding system of the building as close to the point of cable entry

as practical.

Features

Front

1 Electric service equipment

2 Power service grounding electrode

system

3Ground clamps

4 Grounding conductors

5 Antenna discharge unit

6Grounding clamp

7 Antenna lead-in wire

# Component Description

1 Power indicator Lights green when your TV is

turned on. Lights red when your

TV is in standby mode.

2Remote control

sensor

Receives signals from the remote

control. Do not block.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments

Dynex DX-LCD37-09-2 User Manual Page 6

Comments to this Manuals

Related products and manuals for LCD TVs Dynex DX-LCD37-09-2