Dynex DX-LCD37-09-2 User Manual download pdf (Page 10)

Setting up your TV

Removing the stand column for

wall-mounting

If you plan to wall-mount your TV, you must remove the stand column

first.

Note: Your TV may look different that the illustrations in this procedure.

To remove the stand column:

1 Lay your TV face down on the edge of the table or work bench

Caution: Make sure that you place your TV on a soft cushion or covering

to prevent damage to the screen or case.

2 Remove the four screws that secure the stand column to your TV,

then remove the stand column.

Connecting an antenna, cable TV, or

satellite TV box

To connect an antenna, cable TV, or satellite TV box:

1 Make sure that your TV’s power cord is unplugged.

2 Connect a 75 ohm coaxial cable to the RF jack on the back of your

TV, then connect the other end of the cable to the antenna, cable

TV, or satellite TV box.

Stand column

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

Dynex DX-LCD37-09-2 User Manual Page 10