Dynex DX-37L150A11 User's Guide download pdf (Page 7)

Installing and removing the standDX-32L/37L/40L/46L

Installing and removing the

stand

You must install your TV into the stand in order for it to stand upright

on a cabinet or other flat surface. If you intend to mount your TV on a

wall or other vertical surface, you must remove the stand column.

Cautions

• Read these instructions carefully before you try to assemble the

stand or remove the stand column.

• Make sure that you handle the TV carefully when attempting to

assemble or remove the stand. If you are not sure of your ability

to do this, contact a professional installer or service technician.

Dynex is not responsible for any damages or injuries that occur

because of mishandling or incorrect assembly.

• Use a soft cushion or covering to prevent scratching or damage to

the TV screen or cabinet.

• The speaker is not intended to support the weight of the TV. Do

not move or handle the TV by the speaker. This can cause

damage that is not covered by your warranty.

• Before assembly or removal of the stand, unplug the power cord.

Installing the stand

Note: Your TV may differ from the illustrations shown.

To install the stand:

1 Remove the stand from the box .

Note: The wide portion of the stand should face the front of the

TV.

2 Lay the TV (screen down) on a flat, cushioned surface.

3 Align the stand with the TV, as shown in the following

illustration.

4 Move the stand gently until the locating ridges on the stand

column align with the locating grooves on the stand.

5 Align the holes in the stand with the holes in the stand column,

then secure the stand to the column with the four M5 screws

provided.

To remove the stand, loosen the four screws.

Installing a wall-mount bracket

To install a wall-mount bracket:

1 Lay your TV face down on a table or bench. Make sure that you

put down a soft cushion or cloth so that your TV is not scratched.

2 Remove the four screws that secure the TV to the base.

3 Remove the four screws holding the stand column to the TV,

then remove the stand column.

Note: The appearance of the TVs in these illustrations may differ from

your actual TV and are for instructional purposes only.

4 Secure the wall-mount bracket to the back of your TV using the

four M6 screws provided with the bracket.

Locators

Locating grooves

Stand

Four M5 screws

Stand

Locating

grooves

Locators

Four M5 screws

Stand column

Remove the stand

column

Remove four

screws

DX-32L-37L-46L150A11_10-0012.book Page 4 Thursday, January 14, 2010 8:30 AM

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Comments to this Manuals

No comments

Dynex DX-37L150A11 User's Guide Page 7

Comments to this Manuals

Related products and manuals for LCD TVs Dynex DX-37L150A11