Dynex 57" Combination Monopod-Tripod - Black Setup Guide download pdf

Center column

Hanging hook

Monopod leg

V1 ENGLISH 14-0371

Storing your tripod

1 Remove your camera.

2 Loosen the center column locks. Raise the column as far as it

will go, then tighten the bottom lock. Lower the top section as

far as it will go.

3 Twist each leg lock counterclockwise and collapse the legs.

4 Wrap your hand around all four leg locks, then twist clockwise

to tighten them all at once.

5 Pull out the leg release tabs and ip the legs up.

Note: You may need to rotate the head slightly so the legs t between

the knobs.

6 Store the tripod into the carrying case.

Important safety instructions

• Make sure that all leg locks are correctly tightened and that the

legs are fully opened before use.

• Do not carry or transport your tripod with camera equipment

attached (for example, over your shoulder or cradled in your

arms).

• Do not expose your tripod to excessive heat or cold, or use near

any ame or re.

• Do not oil or grease any part of the tripod.

• Do not use any solvents or thinners to clean your tripod. Use

only a mild detergent and wipe dry with a soft, lint-free cloth.

• Do not exceed the load limit of this tripod.

Specications

• Maximum operating height: 57.1 in. (145 cm)

• Minimum operating height: 6.7 in. (17 cm)

• Folded height (reversed legs): 13.4 in. (34 cm)

• Net weight: 2.7 lbs (1.24 kg)

• Max operating load: 8.8 lb (4 kg)

• Number of leg sections: 5

• Quick release thread: 1/4 in. (0.6 cm)

• Panoramic angle: horizontal: 360° and vertical: 90°

• Material: aluminum alloy

One-year limited warranty

Visit www.dynexproducts.com for details.

Contact Dynex:

For customer service, call 800-305-2204 (U.S. and Canada) or

01-800-926-3020 (Mexico)

www.dynexproducts.com

DYNEX is a registered trademark of BBY Solutions, Inc.

Registered in some countries.

Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richeld, MN 55423 U.S.A.

QUICK SETUP GUIDE

DX-TRPMN57

57" Compact

Tripod-Monopod Combo

Before using your new product, please read

these instructions to prevent any damage.

Converting to a monopod

1 Holding the tripod rmly, unscrew the monopod leg from the

main tripod assembly.

2 Unscrew the center column locking screws, unscrew the bottom

hanging hook, then remove the center column from the tripod

base.

3 Screw the center column (with ball head) into the monopod leg.

4 To adjust the height, unscrew the leg twist locks, extend the leg

to the height you want, then tighten the leg locks.

1 2

Summary of Contents

Page 1 - Tripod-Monopod Combo

Center columnHanging hookMonopod legV1 ENGLISH 14-0371Storing your tripod1 Remove your camera.2 Loosen the center column locks. Raise the column as

Page 2 - Using your tripod

Hanging hook Package contents• Tripod• Carrying case• Quick Setup GuideFeatures• Compact portable size, with built in bubble level, can suppor

Comments to this Manuals

No comments

Dynex 57" Combination Monopod-Tripod - Black Setup Guide

Browse online or download Setup Guide for Tripods Dynex 57" Combination Monopod-Tripod - Black. Dynex 57" Combination Monopod-Tripod - Black Quick Setup Guide User Manual

Summary of Contents

Comments to this Manuals