Dynex DX-PS350W User Manual download pdf (Page 2)

Dynex 350W Power Supply

Contents

Français ....................................................... 3

Español ........................................................ 4

Installing the power supply

To install the power supply:

1 Check the new power supply’s red voltage switch on the back of

the power supply, and change the setting if necessary. The setting

should be 115V for use in North America, and 230V for use in

Europe and other countries.

Caution: setting the incorrect voltage can damage the power

supply and connected equipment, and may void your warranty.

2 Turn off your computer, then unplug the power cord.

3 Open your computer case according to the instructions in its user

guide.

4 Disconnect all power supply cables connected to the system board

and other internal devices (such as drives and fans).

5 Remove the old power supply from your computer, then install

your new Dynex power supply into the computer case.

Note: Because installation instructions vary according to the type

of computer case, see your computer’s user guide for more

detailed instructions.

6 Reconnect all power supply cables to the system board and other

internal devices (such as drives and fans).

7 Make sure that you’ve made all necessary power connections,

then close the computer case.

8 Make sure that the power supply’s power switch is on.

9 Plug the AC power cord into the new power supply, then turn on

your computer. You are done.

Troubleshooting

• Make sure that the AC power cord is firmly plugged into the power

supply’s AC power connector.

• Make sure that the AC power outlet is in good condition.

• If the computer is plugged into a power strip, make sure that the

power strip is turned on.

• Make sure that the power supply’s AC voltage switch is set to the

correct voltage.

• Make sure that the power supply’s system board power connector

is firmly plugged into the system board.

• Make sure that the power supply’s internal device power

connectors are all firmly connected to the appropriate devices.

Legal notices

Enterprise Services, Inc. Other brands and product names are trademarks

or registered trademarks of their respective holders. Specifications and

features are subject to change without notice or obligation.

Specifications

Output cable

AC input

Voltage switch

Power switch

3.2 inch (8 cm) fan

Vac~Input

Voltage

115/230V

Current

7/4 A

Frequency

60/50 Hz

VDC + 3,3 V +5V +12V -12V -5V +5V

Black Green Gray

Maximum DC28 A 30 A 19 A 0.8 A0.5 A2.0 ACOM PS-ON PG

Output Total 350W19 A 0.8 A0.5 A2.0 AReturn Remote POK

• Complies with Intel ATX 12V

•Fan speed control

•Low acoustic noise

• This Class B digital apparatus complies with Canadian ICES-003.

DX-PS350W_FINAL.fm Page 2 Wednesday, June 22, 2005 1:24 PM

1 2 3 4 5 6

Comments to this Manuals

No comments

Dynex DX-PS350W User Manual Page 2

Comments to this Manuals