Dynex DX-400WPS User Manual

Browse online or download User Manual for Tools Dynex DX-400WPS. Dynex DX-400WPS User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 5
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
FAQs
Dynex 400-Watt ATX Power Supply
(DX-400WPS)
June 30, 2011
Setup............................................................................................................................................... 1
Wire Configuration ........................................................................................................................ 4
Hardware Issues ............................................................................................................................ 4
General ........................................................................................................................................... 5
Setup
1. How do I set up my Power Supply?
Have you tried using your User Guide to help you through this process? If more
help is needed, follow the steps below.
a. Turn your computer off.
b. Unplug the power cable from your computer.
c. Remove the side panel on your computer, so you can access the power
supply and connectors.
d. Disconnect all power supply connections from the motherboard and
peripheral devices, such as hard drives, optical drives, video cards and
fans. Make sure to note cables you are removing for when you need
to reconnect them later.
e. Remove the old power supply from your computer case and install your
new Dynex power supply, securing it to the computer case with the
appropriate screws.
Page view 0
1 2 3 4 5

Summary of Contents

Page 1 - (DX-400WPS)

FAQs Dynex 400-Watt ATX Power Supply (DX-400WPS) June 30, 2011 Setup...

Page 2

f. Reconnect all power supply cables. Make sure that each connection is secure. Reference your notes from when you removed the old power supply to

Page 3

ii. The floppy drive power connector to the floppy drive. iii. The Serial ATA connector to any devices that have a Serial ATA interface. iv. The 6

Page 4 - Hardware Issues

Wire Configuration 2. What should the connectors look like? Hardware Issues 3. Nothing happens when I try to start up my computer.  Make sure t

Page 5 - General

5 General 4. Where can I get more information about my power supply?  Refer to your User Guide or the Dynex Website: o http://www.dynexproducts.

Comments to this Manuals

No comments